User Manual

12
■
Using the Built-In Effects
The SV150 SILENT Violin™ features a built-in DSP (Digital Signal Processor) that can be
used to add any of the processor’s 24 effects including reverb to make playing more enjoy-
able.
Effect name
Parameter: Selected Value
1
As described in the previous “Sound Output Basics” sec-
tion, connect the instrument to the Control Box and make
the proper settings.
2
Press the SOUND button on the Control Box to call up
the display shown on the right.
3
Using the + and – buttons, select an EFFECT (No. 1-25)
* Effect “No. 25 No Effect” switches the effect OFF.
If a parameter appears below the effect name, press the
SOUND button to select the parameter, then use the +/–
buttons to set the parameter value.
* Holding the + or – button changes the value continu-
ously. Also, pressing the + and – buttons simultane-
ously reverts the value to its factory default value.
Effect No.
Tempo
Volume
Beat
■
Using the Built-In Metronome
* The built-in metronome operates even if the instrument is not connected to the Control Box, and
can be heard through the stereo inner earphones or through the LINE OUT jack.
1
Press the METRONOME button on the Control Box to
call up the display shown at the right.
2
Press the METRONOME button to select the item you
want to set in the display, then use the +/– buttons to set
the value.
* Holding the + or – button changes the value continu-
ously. Also, pressing the + and – buttons simultane-
ously reverts the value to its factory default value.
q
= Sets the quarter note tempo (32-280). The
default value is 120.
Beat: Sets the beat (0-7 beats, 8-beat, triplet, 16-
beat). The default value is 4-beat.
Volume: Sets the volume level (0-30). The default
value is 20.
3
Press the ENTER button to start the metronome. Press
the button again to stop the metronome.
02_SV150S_En_R3.indd 12 14/01/23 13:51