Owner`s manual

16
En
The unit has dual built-in subwoofers; however you can connect an external subwoofer
when you want to enhance low frequency sound. Connect a subwoofer to the
SUBWOOFER OUT jack of the unit.
NOTE
• Use an external subwoofer with built-in amplifier.
You can change the dynamic range to make sounds easy to hear at a low volume.
1 Turn off the unit.
2 Hold down the key for the desired mode for more than 5 seconds.
The unit turns on with the selected setting.
Three settings are available (see below).
You can confirm the setting status by the lights of the indicator, when the unit is turned
on.
NOTE
• Normal is set as default.
Using an external subwoofer
Mono input
Pin cable for subwoofer
(commercially available)
Unit (rear)
Overhead view
Making sound easy to listen at low volume
Setting Description Indicator
Normal Automatically adjusts the dynamic range
based on the volume level of the source.
Lights up in green
Standard Compresses the dynamic range to suit a
living room environment, etc.
Lights up in orange
Maximum Does not compress the dynamic range.
Lights up in red
Returns to Normal
Sets to Standard
Sets to Maximum