User Manual
Table Of Contents
- Table of Contents
- PRECAUTIONS
- NOTICE
- Information
- Main Features
- Getting Started
- 1 Preparing the Power Supply
- 2 Enjoy Playing the Piano
- 3 Playing Back and Recording Songs
- 4 Other Important Functions (UTILITY)
- 5 Connecting to Other Devices
- Appendix
TA3 TC3 SH3 SC3 Owner’s Manual
68
The Bluetooth-equipped device (such
as smart device) cannot be
connected to the instrument.
The Bluetooth function is turned off on this instrument or on the Bluetooth-equipped device.
Make sure that the Bluetooth function is turned on both devices. The Bluetooth on/off of this
instrument can be set in Function F7.5 (page 51).
The Bluetooth-equipped device is not paired with this instrument. The device and this
instrument need to be paired to each other (page 59).
This instrument and the Bluetooth-equipped device are too far apart. Use the device in close
proximity to this instrument.
There is a device (microwave oven, wireless LAN device, etc.) that outputs signals in the
2.4 GHz frequency band nearby. Move the instrument away from any devices that might be
emitting radio-frequency signals.
Sound input via Bluetooth is
interrupted.
The output volume of the Bluetooth-equipped device connected to this instrument is too low,
resulting in the sound being cut off via the Noise Gate after it is input to this instrument.
Increase the output volume of the device. The volume level reproduced via this instrument can
be adjusted by using the [VOLUME] control.
Sound input to the [AUX IN] jacks is
interrupted.
The output volume of the external device connected to the [AUX IN] jack is too low. Increase
the output volume of the external device. The volume level reproduced via this instrument can
be adjusted by using the [VOLUME] control. The AUX IN Noise Gate function may cut off
wanted soft sounds; if this happens, set the function to off in Function F8.2 (page 52).
Problem Possible Cause and Solution