User Manual

Chapter 11 Custom control panels
Amp Editor Owner’s Manual
181
Context menu
The context menu that appears when you right-click in the window will differ depending on whether you’re in
Operation mode or Design mode.
 The context menu in Operation mode
Some of the commands shown in the Operation mode context menu are also shown in Design mode.
 [Design Mode]
Switches between Design mode and Operation mode. When you’re in Design mode, a check mark is shown at
the left of the command name.
 [Peak Hold]
Turns the level meter’s peak hold on/off and resets it.
 [On]
Selecting this will add a check mark, and peak hold will be turned on. Selecting this when a check mark is
already shown will turn peak hold off.
The peak hold on/off setting is valid only within Amp Editor.
 [Reset]
Resets peak hold.
• Peak Hold is a function that causes the maximum signal level value to remain visible.
 [Level Meter Enable]
Specifies whether the level meters will be enabled.
 [Add Parameter to Parameter Link] (when you right-click on a control)
Allows you to add the parameter of the right-clicked control to a group, or to create a parameter link group
(page 161).
 [Open Parameter Link]
Opens the “Parameter Link” dialog box (page 163). Here you can view or edit the status of parameter link.
 [Close All Editor Windows]
Closes all of the editor windows.
NOTE