User Manual

XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner’s Manual
16
Connections and Setting Up
This chapter explains how to set up the XMV to input analog
signals.
If you are using the XMV along with the MTX, refer to the
“MTX Setup Manual.” Refer to this manual for details regard-
ing the following items, even if you are using the XMV along
with the MTX.
• Making settings for speaker output
• Connecting the speaker output connectors
• Making high pass filter (HPF) settings
• Lowering the brightness of the indicators and the display
• Locking the panel
Here we will make and verify the input/output settings as out-
lined below.
 Rack-mounting the Unit
Refer to “Precautions for Rack Mounting” (page 8), and
mount the XMV in your rack.
 Checking the Device Setup DIP Switch Set-
tings
Make sure that all of the rear panel’s device setup DIP
switches (page 13) are in the upward position.
 Connecting the Analog Inputs (Euroblock)
Connect the analog outputs of your mixer or other device to
the analog input connectors (page 15).
You must use the supplied Euroblock plugs with tabs.
If these have been lost, please contact your Yamaha dealer.
Setup for Analog Signal Input
Explanation Page
Rack-mounting the Unit 16
Checking the Device Setup DIP Switch Settings 16
Connecting the Analog Inputs (Euroblock) 16
Making Settings for Speaker Output17
Connecting Speaker Cables 18
Connecting the Power Cord 19
Turning the Power On 19
Enabling Analog Input19
Making High Pass Filter (HPF) Settings 19
Checking the Wiring 20
Lowering the Brightness of the Indicators and the
Display
20
Locking the Front Panel 20
CAUTION
Steps earlier than “Turning the Power On” must be per-
formed with the power off. If you perform these steps with
the power on, the settings might not be applied, or you
might be subject to electrical shock if you touch the con-
nectors.
12345678
Cable preparation
• To prepare the cable for attachment to a Euroblock
connector, strip the wire as shown in the illustration
using stranded wire to make connections. With a
Euroblock connection, stranded wires may be prone
to breakage because of metal fatigue due to the
weight of the cable or due to vibration. Bundle the
cables and the Euroblock tabs using the supplied
cable ties (page 17). When rackmounting your
equipment, use a lacing bar when possible to bun-
dle and fasten the cables.
• If cables will be frequently connected and discon-
nected, as in the case of a portable installation, we
recommend that you use f
errules
with insulation
sleeves. Use a ferrule whose conductor portion has
an external diameter of 1.6 mm or less, and a length
of approximately 7 mm (such as the AI0,5-6WH
made by the Phoenix Contact corporation).
approx.
7 mm
approx.20 mm
NOTE
Do not tin (plate with solder) the exposed end.
1.6 mm or less
approx.
7 mm