User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 8 Device Properties window
Amp Editor Owner’s Manual
132
[General] tab (XMV)
Here you can confirm the DIP switch settings and specify each channel’s frequencies. You can change these set-
tings only when online.
q Output Setup
This section displays the [SPEAKERS] DIP switch settings on the XMV’s rear panel.
• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have
been set to something other than the specified combination. For more information on the [SPEAK-
ERS] DIP switches, refer to the XMV Owner’s Manual.
w HPF
This section enables you to specify the HPF frequencies. You can select 40Hz/80Hz for high impedance, and
Off, 40Hz or 80Hz for low impedance.
• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have
been set to something other than the specified combination.
q
w
NOTE
NOTE