User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
36
• Output configuration settings (Speaker Property - Config)
Y-S3 automatically generates the output system configuration to suit each speaker array type and displays them in
the Config view in Speaker Property You may adjust the input signal level, source type, delay, EQ, speaker processor
and amp model. To reflect the settings in calculation results, click .
Input Level
Input the input signal level in dBu. This level denotes the signal level at the input of the processor. The maximum is
24 dBu and the minimum is -10 dBu.
Source
Display the type of sound source used. You can select “Sine (Peak-to-RMS 3dB)”, “Pink (Peak-to-RMS 6dB)”, or “Music
(Peak-to-RMS 10dB)”. To change your selection, click to open the Project Properties window, then select a type
from the “Peak Factor of Source Signal” list box. “Sine” has a 3 dB difference between the peak signal and RMS, “Pink”
has 6 dB and “Music” has 10 dB. Select the peak-to-RMS level setting you want to use in your design. These levels are
used by the clip level indicator and for auto tuning. See “Clip indicator” and “Auto tuning” in this chapter.
Help for icons
Click to open the Help for icons window, which explains the meanings of the buttons in the Config view.