User Manual

6
In order to remotely control an external head amp con-
nected via the M7CL-48ES’s slot, an EXTERNAL HA tab
has been added to the VIRTUAL RACK window which
appears when you press the RACK button.
q COMM PORT
This specifies whether the external head amp connected
via the M7CL-48ES’s slot will be remotely controlled. To
enable remote control, press the [SLOT 1] button to make
it light. If you do not wish to use remote control, press the
[NONE] button to make it light.
You can now perform operations such as on/off by operat-
ing an encoder while holding down a user-defined key to
which the ALTERNATE function is assigned.
ALTERNATE mode is the state in which the user-defined
key to which the ALTERNATE function is assigned has
been pressed (i.e., is in the On state).
In ALTERNATE mode, the following encoders will
change their operation as described.
• [HA] encoder
Turn the encoder to adjust the attenuation value. If
[ATT] is selected for HA KNOB FUNCTION in the
PREFERENCE page of the USER SETUP popup win-
dow, the encoder will adjust the head amp gain.
• [MIX/MATRIX] encoder
Turn the encoder to switch the corresponding send
between PRE /POST.
Press the encoder to switch the corresponding send on/
off.
• [HPF] encoder
Press the encoder to switch the high-pass filter on/off.
• [DYNAMICS 1] encoder
Press the encoder to switch DYNAMICS 1 on/off.
• [DYNAMICS 2] encoder
Press the encoder to switch DYNAMICS 2 on/off.
Remote control of an external head
amp connected to a slot
q
• Remote control is not possible if the port that transmits or receives
MIDI messages is specified as SLOT 1. To allow remote control,
assign the MIDI port to other than SLOT 1.
• For details on operation, refer to “Remotely controlling an external
head amp” in the M7CL V3 owner’s manual.
NO TE
ALTERNATE function added
• The ALTERNATE function lets you choose either LATCH or
UNLATCH. If UNLATCH is selected, ALTERNATE mode will be on
only while you hold down the user-defined key. If LATCH is selected,
ALTERNATE mode will toggle on/off, allowing you to use the function
without having to hold down the user-defined key.
• ALTERNATE mode will turn off when you switch between the OVER-
VIEW screen and the SELECTED CHANNEL VIEW screen, when a
popup window appears, and so on.
• In ALTERNATE mode, “ALT” will be displayed as the user name in
the function access area.
NO TE
• In ALTERNATE mode, encoder functions in the SELECTED CHAN-
NEL section other than those listed above are disabled.
NO TE