User Manual

There are three User Defined Block protection modes.
•
Off mode
The unprotected state.
•
View Only mode
A protected User Defined Block or a component editor inside the block can be opened, but the
configuration and parameters cannot be changed. Components in the User Defined Block are not shown
in the “Parameters” area.
A lock icon ( ) is shown at the lower left of the component editor in a protected block.
•
Protect mode
A protected User Defined Block cannot be opened. Components in the User Defined Block are not shown
in the “Parameters” area. Use this when you want to keep the content completely concealed.
A lock icon ( ) is shown at the upper left of the protected block.
To apply protection, proceed as follows.
1.
Select the User Defined Block that you want to protect.
If you select multiple User Defined Blocks, they will be protected in the same mode.
2. In the “Properties” area, use [Lock Mode] to specify the lock mode that you want to apply.
3. As necessary, repeat steps 1 and 2 to specify the lock mode for other User Defined Blocks.
4.
Choose [Edit] menu → [Protect User Defined Block] from the [Tools] button in the “Device” sheet.
The “Protect User Defined Block” dialog box appears.
Enter the PIN code and click the OK button to set the same PIN to all User Defined Blocks whose Lock Mode is
"Protect".
13. Audio Processors: DME7
ProVisionaire Design V1.2 User Guide | 141