User Manual

The SATELLITE connectors on the VXS10S/VXS10ST allow for the connection of satellite mid-high speakers to be used at the same

amplifier output. This gives the benefit of reducing the number of amplifier channels and takes advantage of the high pass filter built in to

the VXS10S/VXS10ST. The high-pass filter is optimized for use with the following recommended speakers.

• Surface mount speaker VXS5 / VXS5W

• Ceiling speaker VXC4 / VXC4W or VXC6 / VXC6W

*VXS5 is used for illustrations/explanations in this guide.

Basic system for stereo playback

Stereo playback with wider coverage

About satellite connection

Recommended satellite speakers

Connection examples

VXS10S + two VXS5 (stereo system)

VXS10S + four VXS5 (stereo system)

VXS10S is a dual voice coil

subwoofer. Audio signal of

CH1+CH2 comes out from

VXS10S subwoofer.

Amplifier

Rear panel of VXS10S

Amplifier

VXS10S is a dual voice coil

subwoofer. Audio signal of

CH1+CH2 comes out from

VXS10S subwoofer.

English

Speaker system satellite guide

PAGE 1
English Speaker system satellite guide About satellite connection The SATELLITE connectors on the VXS10S/VXS10ST allow for the connection of satellite mid-high speakers to be used at the same amplifier output. This gives the benefit of reducing the number of amplifier channels and takes advantage of the high pass filter built in to the VXS10S/VXS10ST. The high-pass filter is optimized for use with the following recommended speakers.
PAGE 2
VXS10S + two VXS5 (monaural system) Here is an alternative system. Note that in this system, as one rather than both voice coils is driven, some specifications, such as the maximum sound pressure level will differ from the product specification sheet. Amplifier VXS10ST + two VXS5 (monaural system) Here is an example of a high impedance system comprising a VXS10ST subwoofer and two monaural satellites, driven from a single amplifier channel.