Operation Manual

Tips
105
Owner’s Manual
Quick GuideTips
Multi/Performance Part mute/solo
■ Muting a Part
1 Make sure that the [MUTE] button's lamp is
turned on.
If the indicator is flashing, press the [MUTE]
button.
2 press one of the [1] - [4] buttons in the
Performance mode or press one of the [1] - [16]
buttons in the Multi mode that you want to mute
and turned the indicator off.
■ Soloing a Part
1 Press one of the [1] - [4] buttons in the
Performance mode or press one of the [1] - [16]
buttons in the Multi mode that you want to solo,
whiile holding the [SOLO] button.
Once you’ve selected an Part for soloing, the
[SOLO] button's lamp flashes, indicating the Solo
function is active and only the selected Part can
be played.
2 To exit from the Solo function, press the
[SOLO] button again.
n When selecting a Multi in the Master mode, the mute/solo
settings apply not to each Part but to each MIDI transmit
channel. Details are the same as for the mute/solo settings in
the Sequence Play mode.
TIP
ELEMENT/PERF. PART/ZONE
8
7
6
5
4
3
21
16
15
14
12 13
11
10
9
MUTE
TRACK
SELECT
SOLO
The example below shows that the Part 3 is muted.
ELEMENT/PERF. PART/ZONE
8
7
6
5
421
16
15
14
12 13
11
10
9
MUTE
TRACK
SELECT
SOLO
Press the buttons simultaneously
The example below shows that the Part 3 is muted.
Keyboard MIDI transmit channel setting
Press the [TRACK SELECT] button so that its indicator
lights, and press any of the Number [1] - [16] buttons
to change the Keyboard MIDI transmit channel in any
mode.
n You can also set the MIDI keyboard transmit channel of the
Voice mode and Performance mode from the Utility mode
([UTILITY] → [F5] MIDI → [SF1] CH → KBDTransCh).
Transpose setting of the keyboard
You can transpose the pitch up or down of the
keyboard in semitone steps or octave steps.
1 Press the [UTILITY] button to enter the Utility
mode.
2 Press the [F1] GENERAL button, then the [SF2]
KBD button.
3 Move the cursor the “Octave” when you want to
shift the key by one octave. Move the cursor
“Transpose” when you want to shift the key by
one semitone.
4 Change the parameter value by using the [INC/
YES], [DEC/NO] buttons and data dial.
5 Press the [STORE] button to store the settings
as the system setting of Utility mode.
If you turn the power off without storing, the currently edited
settings will be lost.
TIP
ELEMENT/PERF. PART/ZONE
8
7
6
5
4
3
21
16
15
14
12 13
11
10
9
MUTE
TRACK
SELECT
SOLO
TIP
SF1
F1
SF2
F2 F3 F4 F5 F6
SF3 SF4 SF5
INFORMATION
CAUTION