Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Connections
• Connecting the speaker cable
2 Loosen the knob.
Red: positive (+)
Black: negative
(-)
Caution
Remove the shorting bars
or
bridges
of
your speakers
to separate the LPF (low pass filter) and HPF (high
pass filter) crossovers.
• Using bi-amplification connections
Tighten the knob and then insert the banana plug
connector
into
the end
of
the corresponding
terminal.
• Connecting the banana plug
(except Europe, Russia, Asia and Korea
models)
Red: positive (+)
Black: negative
(-)
10
mm
(M
In)
I~
1 Remove approximately
10
mm (0.4 in)
of
insulation from the end
of
each speaker
cable and then twist the exposed wires
of
the
cable together
to
prevent short circuits.
3 Insert one bare wire into the hole on the side
of
each terminal.
4 Tighten the knob
to
secure the wire.
This unit allows you to make bi-amplification connections
to one speaker system. Check
if
your speakers support bi-
amplification.
To
make the bi-amplification connections, use the FRONT
and SURROUND BACK/BI-AMP terminals as shown
below.
To
activate the bi-amplification connections, set
"BI-AMP" to
"ON"
in "ADVANCED SETUP" (see
page 109).
Front speakers
Right Left
il
When you make the conventional connection, make sure that the
shorting bars are put into the terminals appropriately. Refer to the
instruction manuals
of
the speakers for details.
16
En