Owner`s manual

Connections
36 En
■ Connecting external amplifiers
This unit has more than enough power for any home use. However, if you want to use external amplifiers, connect the external amplifiers to
the PRE OUT jacks. Each PRE OUT jack outputs the same channel signals as the corresponding SPEAKERS terminals.
y
Use the external amplifiers in the following cases:
– when you want to add more power to the speaker output
– when you want to use another amplifier for your presence of sounds
– when you want to enjoy the 11.2-channel surround sound in the main zone with activating the other zones (see page 133)
Pre-amplifier mode
If you want use the external amplifiers for the all channels in the main zone, set “PREAMP MODE” to “ON” in the advanced setup (see
page 143). When “PREAMP MODE” is set to “ON”, the power consumption is reduced.
PRE OUT jack Output audio channel
1 FRONT
Front left/right
2 SURROUND
Surround left/right
3 SUBWOOFER
Subwoofer left/right (see page 26)
4 SUR.BACK
Surround back left/right *
5 FRONT PRESENCE
Front presence left/right
6 REAR PRESENCE
Rear presence left/right
7 CENTER
Center
PRE OUT
SURROUND CENTER
(FRONT) (SINGLE)
SUR. BACK
(REAR)
SUBWOOFER
FRONT
PRESENCE
REAR
PRESENCE
FRONT
R
L
12 3
7
456
* When you only connect one external amplifier for the surround back
channel, connect it to the SINGLE jack.
Note