Natural AV Receiver Owner's Manual

45
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
SET MENU
10 DOLBY D. SET (Dolby Digital
set)
This setting is effective only when this unit decodes
Dolby Digital signals.
■ 10A LFE LEVEL
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital signal. The LFE signal carries the low-
frequency special effect sound which is only added to
certain scenes.
Control value (dB): –20 to 0
Initial setting: 0 dB for both SPEAKER and
HEADPHONE
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
■ 10B D-RANGE (dynamic range)
Use this feature to adjust the dynamic range.
Choices: MAX, STD (standard), MIN
Initial setting: MAX for both SP (speaker) and HP
(headphones)
• Select MAX for feature films.
• Select STD for general use.
• Select MIN for listening to sources at an extremely
low volume level.
L-LEVEL BST
H-LEVEL CUT
0.0
0.0
1.0
1.0
MAX
11 DTS LFE LEVEL
This setting is effective only when this unit decodes DTS
signals.
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a DTS
signal. The LFE signal carries the low-frequency special
effect sound which is only added to certain scenes.
Control range (dB): –10 to +10
Initial setting: 0 dB for both SPEAKER and
HEADPHONE
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
12 6.1/ES AUTO
Use this feature to switch the auto mode of the Dolby
Digital Matrix 6.1 or DTS ES decoder on or off.
Choices: ON, OFF
Initial setting: ON
ON
Select this to allow this unit to automatically turn on the
Dolby Digital Matrix 6.1 or DTS ES decoder when a
signal with the appropriate identification is detected.
OFF
Select this if you want to turn on or off the Dolby Digital
Matrix 6.1 or DTS ES decoder manually by pressing 6.1/
ES on the remote control.
Dialog
level
Input level
Output level
STD
Dialog
level
Input level
Output level
MIN
Dialog
level
Input level
Output level
Note
• When you select MIN, the sound output may be faint because
some Dolby Digital signals are not compatible with the
minimum-level dynamic range. In this case, select MAX or
STD.