Owner's Manual

58 En
The advanced setup includes more parameters for basic
operation of this unit such as turning a bi-amp connection
on and off and initializing user settings. This section
describes what those parameters are and how to change
them.
1 Set this unit to standby.
2 Press AMAIN ZONE ON/OFF while
pressing and holding PSTRAIGHT on the
front panel.
The ADVANCED SETUP menu appears on the front
panel display.
3 Rotate the OPROGRAM selector to select
the parameter you want to change.
y
• Set values are placed in XXX of the following parameters on an
actual display screen.
• The default setting are marked with “*.”
SP IMP. -XXX
Selects output impedance of this unit according to
connected speakers. When you connect 4-ohm
speakers to the FRONT jacks of the SPEAKERS
terminals, set “SP IMP.” to “6ΩMIN.”
REMOTE ID -XXX
Selects a remote control ID for this unit. When using
multiple Yamaha AV receivers, you can operate them
with a single remote control by setting them to have
the same remote control ID. By setting the receivers
to have different remote control IDs, you can operate
them with their respective remote controls.
BI AMP - XXX
Switches on and off of bi-amp connection of main
speakers. For bi-amp connection, see page 13.
SCENE IR -XXX
Selects whether or not to transmit the SCENE control
signals to an external component connected to the
REMOTE jacks on this unit when BD/DVD or CD
SCENE function is selected. If “ON” is selected and a
playback component that supports the SCENE link
playback, such as a Yamaha DVD player, is
connected to the REMOTE OUT jack of this unit,
remote connection automatically starts playback
when a different SCENE key is selected.
MON.CHK - XXXX
Adds upscaling limitation on output signals to a video
monitor connected to this unit via the HDMI OUT
jack.
INIT-XXXXXXXXX
Initializes various settings stored in this unit. You can
select an initialization method from the following.
4 Press PSTRAIGHT a few times to select the
value you want to change.
The value selected here becomes effective when this
unit is turned on the next time. You can change
multiple settings by repeating steps 3 and 4.
5 Press AMAIN ZONE ON/OFF, turns off this
system, and press AMAIN ZONE ON/OFF
again.
The value set in step 4 becomes effective, and this
unit turns on. When you select initialization in step 3,
the initialization is performed.
Advanced setup
Choices: 6 MIN/8 MIN*
Choices: ID1*/ID2
Choices: ON/OFF*
Choices: ON*/OFF
ADVANCEDSETUP
Choices: YES*/SKIP
Choices: DSP PARAM/VIDEO/ALL/CANCEL*
DSP PARAM Resets all parameters of sound field
programs.
VIDEO Resets video conversion settings
(resolution/aspect) in the SETUP
menu and the OSD menus display
position.
ALL Resets this unit to initial factory
settings.
CANCEL Initialization.