Owner's Manual

23 En
Optimizing the speaker setting for your listening room (YPAO)
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
Press kCursor n once, and select “Retry” or
“Exit” using kCursor l / h and then press
kENTER.
Retry
Performs the automatic setup procedure again.
Exit
Terminates the measurement and the automatic setup
procedure.
y
• See page 63 for details on error messages.
• When “E-5:NOISY” appears, you can continue measurement. To
continue measurement, select “Proceed.” However, we recommend that
you solve the problem first and then perform measurement again.
If a problem occurs during measurement, “WARNING” is
displayed on the result display screen. Check the error and
solve the problems.
y
• See page 64 for details on warning messages.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform the
automatic setup procedure again.
1 If “→” is displayed on the left of “WARNING”
on the result display screen, press
kENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using kCursor h.
2 To return to the top result display, press
kENTER again.
When an error message is displayed
during measurement
ERROR
Don't

operate
.E-9:USER CANCEL
[ENTER]:Return
any function
>RetryExit
[]/[]:Select
p[
When a warning message is displayed
after measurement
WARNING
Reversechannel
W-1:OUTOFPHASE
[ENTER]:Return
FL---
CENTER
------
SBL---
SL---
[]/[]:Select
p[