Operation Manual

97 En
Using multi-zone configuration
ADVANCED
OPERATION
English
Operating Zone 2
Rotate the
I
INPUT selector to select the
desired input source while the ZONE2 indicator
is flashing in the front panel display.
• Select “TUNER” as the input source to use the TUNER
features in Zone 2. For details about the TUNER
operations, see “FM/AM tuning” on page 50.
• Select “V-AUX” as the input source to use iPod
features in Zone 2. For details about the iPod
operations, see “Using iPod™” on page 56.
y
You must complete this step within 10 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
9
ZONE CONTROL on the front panel again.
Set Zone 2 to the standby mode
Press
8
ZONE 2 ON/OFF to set Zone 2 to the
standby mode.
■ Controlling Zone 2 with the remote
control
Activating the Zone 2 operation mode
Set the operation mode selector to
L
AMP and
then press
J
SELECT k repeatedly to select the
zone you want to control.
“ZONE 2” is displayed in the display window (
J
) on the
remote control.
Turning on or off Zone 2 using the remote control
I
POWER and
H
STANDBY on the remote control
work differently depending on the selected zone that
appears in the display window (
J
) on the remote control.
• When the main zone, Zone 2 mode is selected, you can
turn on the main zone or Zone 2 or set them to the
standby mode individually.
• When the all mode is selected, pressing
I
POWER
turns on the main zone and Zone 2 simultaneously and
pressing
H
STANDBY sets them to the standby mode
simultaneously.
• When the remote control is in the main zone mode, “MAIN”
appears for a few seconds when
I
POWER or
H
STANDBY
is pressed.
• “ALL” appears in the display window (J) on the remote
control only when SELECT n is pressed.
Selecting the input source of Zone 2
Press one of the input selector buttons (
B
) to
select the input source of the selected zone.
If the remote control is used to select the input source, “2;
name of the selected input area” is displayed in the display
window (
J
) on the remote control when Zone 2 is
selected respectively.
The selected input source is shared across all zones.
Operate the following operations after activating the Zone 2
operation mode.
SELECT
TV
SOURCE
AMP
Control mode
Display window
(J)
POWER
and
STANDBY
Main zone
mode
Name of the selected
input area
Turns on the main
zone only or sets it to
the standby mode.
Zone 2 mode
“ZONE 2” or “2;name
of the selected input
area”
Turns on Zone 2 or
sets it to the standby
mode.
All mode
“ALL”
I
POWER: turns
on the main zone and
Zone 2.
H
STANDBY: sets
the main zone and
Zone 2 to the standby
mode.
Notes
Note