Owner's Manual

30
CONNECTIONS
If you are to use 4 or 6 ohm speakers, set “SP
IMP.” to “6ΩMIN” as follows BEFORE using this
unit.
1 Make sure this unit is turned off.
See page 31 for details about turning on or off this
unit.
2 Press and hold STRAIGHT (EFFECT) on the
front panel and then press MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the PROGRAM selector on the front
panel to select “SP IMP.”.
The following display appears in the front panel
display.
4 Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6ΩMIN”.
The following display appears in the front panel
display.
5 Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
Setting the speaker impedance
CAUTION
ON/OFF
ZONE 2
ON/OFF
ZONE
CONTROL
NEXTEDIT
EFFECT
MEMORY FM/AM
PRESET/TUNING A/B/C/D/E
PROGRAM
l PRESET/TUNING h
TUNING MODE
INPUT MODETONE CONTROLSTRAIGHT
SPEAKERSPHONES
MAIN ZONE
MASTER
SILENT CINEMA
BA
MULTI CH
INPUT
VOLUME
INPUT
ON OFF
LEVEL
MAN'L/AUTO FM AUTO/MAN'L
OPTIMIZER MIC
PURE DIRECT
S VIDEO VIDEO OPTICALL AUDIO R
VIDEO AUX
32,4
2,5
EFFECT
STRAIGHT
MASTER
ON OFF
While holding
down
PROGRAM
SP IMP.-8 MIN
Note
EFFECT
STRAIGHT
SP IMP.-6 MIN
MASTER
ON OFF