Owner`s manual
En 76
Operating the ADVANCED SETUP menu
Looking at the front display to configure the system settings of the unit.
1 Switch the unit to the standby mode if the unit is turned on.
2 Press while pressing and holding STRAIGHT on the front panel.
3 Press PROGRAM to select the item.
4 Press STRAIGHT to select the value.
5 Press to switch the unit to the standby mode, and then switch it on
again.
The settings become effective and the unit is turned on.
Features of the ADVANCED SETUP menu
Changing the speaker impedance
(U.S.A. and Canada models only)
Changes the unit settings depending on the impedance of the speakers connected.
Settings
Changing the remote control ID
The remote control of the unit can only receive signals from a receiver which has an
identical ID (remote control ID). When using multiple Yamaha AV receivers, you can set
each remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (Default), ID2
■ To change the remote control ID of the remote control
Perform each of the following steps within 1 minute. Settings will be automatically
stopped if more than 1 minute passes since the last operation.
1 Press CODE SET on the remote control using a pointed object such as the tip of a
ballpoint pen.
2 Press SOURCE/RECEIVER.
3 Enter “5019” (to switch to ID1) or “5020” (to switch to ID2) with the numeric keys.
Once the remote control code is registered successfully the remote control will blink twice.
If SOURCE/RECEIVER blinks 6 times, the registration failed. Repeat from step1.
• If the remote control ID is changed, the registered settings of the remote control code (p.79) are kept.
Configuring the system settings of the unit (ADVANCED SETUP menu)
Items Descriptions
SP IMP. (U.S.A. and Canada models only) Sets the impedance of speakers.
REMOTE ID Changes the remote control ID of a receiver.
BI-AMP Switches the bi-amp connections on or off.
TV FORMAT Specifies the TV’s color encoding format.
MON.CHK Removes the up-scaling limitation on HDMI video output.
TU
(Asia and General models only) Selects one of the following FM/AM
frequency steps.
INIT Initializes various settings for the unit.
key
STRAIGHT keyPROGRAM key
6ΩMIN Select the impedance when 6Ω speakers are connected.
8ΩMIN (Default) Select the impedance when speakers above 8Ω are connected.
SP IMP. -8 MIN
REMOTEID-ID1