Owner’s Manual

39 En
Editing surround decoders/sound field programs
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
■ Straight Enhancer/7ch Enhancer only
EFCT LVL
Adjusts the Compressed Music Enhancer effect level.
When the high-frequency signals of the source is
emphasized too much, set the effect level to “Low.” To
reduce the effect, set this parameter to “Low.” To increase
the effect, set it to “High.”
You can customize decoder effects by setting the
following parameters. For kinds of decoders, see page 26.
■ When PLIIx Music/PLII Music is selected
Panorama
Adjusts the soundscape of the front sound field. Sends
stereo signals to the surround speakers as well as the front
speakers for a wraparound effect.
Dimension
Adjusts the difference in level between the front sound
field and the surround sound field. You can adjust the
difference in level created by the software being played
back to obtain the preferred sound balance. The surround
sound gets stronger as you make the value more negative
and the front sound gets stronger as you make the value
more positive.
CT Width
You can spread the center sound toward left and right
according to your preference. Set this parameter to 0 for
outputting the center sound from the center speaker only,
or to 7 for outputting it from the front left/right speaker.
■ When Neo:6 Music is selected
C.Image
Adjusts the front left and right channel output relative to
the center channel to make the center channel more or less
dominant as necessary.
Choices: High*/Low
Decoder parameters
Choices: Off*/On
Adjustable range: -3 to STD* to +3
Adjustable range: 0 to 3* to 7
Adjustable range: 0.0 to 0.3* to 1.0