Owner’s Manual

20 En
Optimizing the speaker setting for your listening room (YPAO)
Press nCursor n once, and select “Retry” or
“Exit” using nCursor l / h and then press
nENTER.
Retry
Performs “Auto Setup” again.
Exit
Terminates the measurement and “Auto Setup.”
y
• See page 53 for details on error messages.
• When “E-5:NOISY” appears, you can continue measurement. To
continue measurement, select “Proceed.” However, we recommend that
you solve the problem first and then perform measurement again.
If a problem occurs during measurement, “W-xx” (xx
indicates the number) is displayed on the front panel
display. Check the error and solve the problems.
y
• See page 54 for details on warning messages.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform “Auto
Setup” again.
1 If a warning message is displayed, press
nENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using nCursor h.
2 To return to the top result display, press
nENTER again.
When an error message is displayed
during measurement
When a warning message is displayed
after measurement
W-1:PHASE