Owner`s manual

73
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
7 Press LEARN again to exit from the setup
mode.
8 Press one of the buttons shaded below to
see if you can control your component. If you
can, the remote control code is correct.
y
If the manufacturer of your component has more than one
code, try each of them until you find the correct one.
“ERROR” appears in the display window if you press a button
not indicated in the respective step, or when you press more
than one button simultaneously.
The supplied remote control does not contain all possible codes
for commercially available audio and video components
(including YAMAHA components). If operation is not possible
with any of the remote control codes, program the new remote
control function using the Learn feature (see “Programming
codes from other remote controls (Learn)”) or use the remote
control supplied with the component.
Function programmed using the learn feature take priority over
remote control code functions.
Use the learn feature if you want to program functions not
included in the basic operations covered by remote control
codes, or an appropriate remote control code is not
available. You can program any of the buttons available in
the component control area (see page 70). The buttons can
be programmed independently for each component.
This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn most
of its functions. However, you may not be able to program some
special signals or extremely long transmissions. (Refer to the
operating instructions for the other remote control.)
1 Set AMP/SOURCE/TV to SOURCE.
2 Press an input selector button to select a
source component.
3 Place this remote control about 5 to 10 cm
(2 to 4 in) apart from the other remote control
on a flat surface so that their infrared
transmitters are aimed at each other.
Notes
LEARN
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
POWER POWER POWER
SYSTEM
STANDBY
AVTV
SLEEP
AUDIO SELECT
A
B
CLEAR
LEARN
RE–NAME
FREQ/RDS
FREQ/RDS
EON
EON
MODE
MODE
PTY SEEK
PTY SEEK
START
START
REC
DISC SKIP
MACROONOFF
Programming codes from other
remote controls (Learn)
Note
AMP
SOURCE
TV
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
SLEEP
AUDIO SELECT
A
B
SELECT
DTV DVR/VCR2VCR 1 DV D
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
POWER POWER POWER
SYSTEM
STANDBY
AVTV
SLEEP
AUDIO SELECT
A
B
5 to 10 cm (2 to 4 in)