manual

99 En
Saving and recalling the system settings (System Memory)
ADVANCED
OPERATION
English
4 Press 4k / n repeatedly to select the desired
memory number (“Memory1” to “Memory6”)
and then press 4h.
“Save: ENTER” appears in the GUI.
y
• If system settings are already stored in the selected
memory number, the stored system parameter settings
appear in the menu screen.
• If system settings are already saved in the selected
memory number, this unit overwrites to old system
settings.
• If you save the system settings to “Memory1” to
“Memory4”, you can load the stored settings by pressing
the corresponding
N
SYSTEM MEMORY buttons (see
page 99).
5 Press
4
ENTER to save the current system
settings to the selected memory number.
y
You can cancel the saving by pressing 4l.
6 Press
G
SET MENU again to exit from GUI
screen.
■ Loading by the
N
SYSTEM MEMORY
buttons
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding
N
SYSTEM
MEMORY buttons.
1 Press one of the
N
SYSTEM MEMORY
buttons on the remote control to select the
desired memory number.
“MEMORY 1 LOAD” (example) appears in the front
panel display.
y
“EMPTY” appears in front panel display if no system
settings are stored in the selected memory number.
2 Press the selected
N
SYSTEM MEMORY
button once more to confirm the selection.
This unit loads the settings stored in the selected
memory number.
Current
Memory1
Memory2
Memory3
Memory Empty
Save: ENTER
Current
Memory1
Memory2
Memory3
Recital/Opera
SpeakerCH 5/4/0.1
LFE Level 0dB
D-Range MAX
PEQ Reset
Stored system parameters in the selected
memory number
Loading the stored system settings
• Before performing the following operations, set the
operation mode selector on the remote control to
D
AMP.
• This unit overwrites the stored settings to the current
settings of this unit. If you do not want to erase the current
settings, save the current settings to any System Memory
number in advance.
4
3
2
1
SYSTEM MEMORY