Owner's Manual

En 10
CONNECTIONS
Connecting speakers
Speaker layout
5.1-channel speaker layout (5 speakers + subwoofer)
Connecting speakers
■ Changing speaker impedance
This unit is configured for 8Ω speakers when it is dispatched from the factory.
When connecting to 6Ω speakers, carry out the following procedure to switch to 6Ω.
1
Set this unit to the standby mode.
2
Press A while pressing and holding STRAIGHT on the front panel.
Release the keys when “ADVANCED SETUP” is displayed on the front panel display.
After approximately 3 seconds, the top menu items are displayed. J1
3
Check that “SP IMP.” is displayed on the front panel.
4
Press STRAIGHT repeatedly to select a “6ΩMIN.”
5
Switch this unit to the standby mode, and then switch it on again.
The power turns on, when the settings you made has been configured.
• Connect at least two speakers (front left and right).
• If you cannot connect all five speakers, give priority to the surround speakers.
• The surround speakers should be placed between 60 degrees and 80 degrees from the listening position.
■ CRT monitors
We recommend that you use magnetically shielded speakers to avoid video distortion, especially for
the front and center speakers near the screen.
If your screen still gets interference from magnetically shielded speakers, move the speakers farther
away from your TV.
60q
60q
80q
80q
Front speaker R
Front speaker L
Center speaker
Surround speaker L
Surround
speaker R
Subwoofer
JJ
1 : See the section on “Extended functionality that can be configured as needed (Advanced Setup menu)” for details on the
Advanced Setup menu (☞
p. 55).
PHONES
SILENT
CINEMA
TONE CONTROL
STRAIGHT
TV
BD
DVD
CD RADIO
INPUT
PROGRAM
SCENE
INFO
MEMORY PRESET FM AM
STRAIGHT
A