Manual

You can adjust the output level of each speaker while

listening to a music source. This is also possible when

playing sources input at the MULTI CH INPUT jacks.

This operation will override the level atljustments made in "Auto

Setup' (see page 35) and "Speaker Level" (see page 109).

Set the operation mode selector to AMP and

then press LEVEL on the remote control

repeatedly to select the speaker you want to

adjust.

{_) LEVEL

S01_CE

li:::'i::)i"iM"i"l'..',,._l'I I Ii.... Front left speaker

I"' iX["i" i 7" iX[" i:::' Center speaker

i:::'i:::q'%.i"i"r..,...,_'i _ _'..i1::' Front right speaker

....c:'i,,...,ii:::,_.. ==_i:::'... Surround righl speaker

S[[[!{{.... Surround back right speaker

....c:'i::,,_...,_i:::'... Surround back lell speaker

,:::'iii:::,i Surround left speaker....,,...,i % :: i.

....,hll" I',:' Subwool'er

i:::,i:::,i..iC:'r>._".,....,_.i Presence left speaker

_:::,i::,i..i,:::'r,H,...,r.._:::' Presence right speaker

-4:--

• Once you press LEVEL on the remote control, you can

also select the speaker by pressing A / V.

• Instead of "SB R" and "SB L", "SB" is displayed if

"Surround Back" is set to either "Small x l" or "Large x l"

(see page 106).

Press <1 / _> on the remote control to adjust

the speaker output level.

• Press C:>to increase the value.

• Press <:1to decrease the value.

Control range: -10 dB to +10 dB

%"lhffeirzl#lel[ell._-%Wl#l;t-_

iii!ii!ii_iiilj_i!_!_iiii! i!i!!_ii_i !iiii_i_!_i_!_!i!il ii_i!_iil i i !iil!i!!iii_!iiiii!i!ii!ii!ii!ii!il!ii!ii!i!!!!iiiii

You can mix down nmlti-channel sources to 2 channels

and enjoy playback in 2-channel stereo.

Set the operation mode to AMP and then press

STEREO on the remote control repeatedly to

select "2ch Stereo".

,'% ... _.. ="" .i .............

You can use a subwoofer with this program when "Bass Out" is

set to "SWFR" or "Both" (see page 107).

• You can also select the "2ch Stereo" mode by rotating the

PROGRAM selector on the front panel.

• You can also select the "2ch Stereo" mode and adjust the

parameter by using GUI screen. See pate 88 for details.

53 En