Manual

l_lql',PPilq'
11 Press ENTER to start the setup procedure.
This unit starts tile auto setup procedure. Loud test
tones are output from each speaker during the auto
setup procedure. During the setup procedure,
"Measuring..." appears in the GUI screen. We
recommend getting out of the room while thus unit is
in the auto setup procedure. The necessary time for
the auto setup procedure depends on the environment
of the listening room and connected speaker (from 30
seconds to 3 minutes).
• To stop the Autu Setup procedure and set this unit to the
pause mode, press one of the cursor buttons (A / V / <1 /
C>) or ENTER. Ill the pause mode, press A to retry the
procedure, and <3 to cancel the Auto Setup procedure.
• If all error nmssage appears and this unit stops the setup
procedure, see the "Auto Setup" section ill
"TROUBLESHOOTING" on page 147, and afier carrying
out the remedy, retry the Auto Setup prucedure.
12 Once all items are set successfully, following
display appears in the GUI screen.
13
If yuu are not satisfied with the results or want to manually
a([iust each parameter, set the parameters ill "Basic" (see
page 104).
• If yuu change speakers, speaker positions, or the layuut of
your listening euvironmeut, run "Auto Setup" again to
recalibrate yuur system.
• The distances displayed in the "Distance" results may be
longer than the actual distance depending on the
characteristics of your subwuofcr.
• IT/the "Equalizing ' results, different values may be set lor
the santo band to provide liner adjustments.
Press SET MENU to exit from the GUI screen.
SETmENU
• Alter you have completed the "Auto Setup" procedure, be
sure tu disconnect the optimizer microphone.
• The optimizer microphone is sensitive to heat. Keep it
away frum direct stmlight and do not place it on top of this
unit.
• Reviewing the result of the auto setup
Use this feature to review the result of the auto setup.
Set the operation mode selector to AMP and
then press SET MENU to turn on the GUI
screen.
_Nmmu
• Press V and select "Setup" to set the measured
values.
• Press/_ and select "Retry" to retry the Auto Setup
procedure.
• Press t::>and select "Detail" to view information
about measurement results and warning messages.
For more details about warning messages, see the
"Auto Setup" section in "TROUBLESHOOTING"
on page 147.
• Press <3 and select "Exit" to exit from the Auto
Setup procedure. If you select "Exit", "Don't
Setup?" appears on the screen. To set the measured
values and exit, select "Yes". To cancel the settings
and exit, select "No".
38 En