Manual
• Speaker Level (Speaker level)
Use this feature to manually balance the speaker levels
between the front left or surround left speakers and each
speaker selected in "SPEAKER SET" (see page 105).
Control range: -10.0 dB to +10.0 dB
Initial setting:
Front L/Front R/Subwoofer/Presence L/
Presence R/Subwoofer: 0.0 dB
CENTER/Surround L/Surround R/Surround Back L/
Surround Back R: 1.0 dB
Control step: 0.5 dB
Select "Front L" to adjust the balance of the front left
speaker.
Select "Front R" to adjust the balance of the front right
speaker.
Select "Center" to adjust the balance of the center
speaker.
Select "Surround L" to adjust the balance of the
surround left speaker.
Select "Surround R" to adjust the balance of the
surround right speaker.
Select "Surround Back L" to adjust the balance of the
surround back left speaker.
Select "Surround Back R" to adjust the balance of the
surround back right speaker.
Select "Presence L" to adjust the balance of the
presence left speaker.
Select "Presence R" to adjust the balance of the
presence right speaker.
Select "Snb'a, oofer" to adjust the balance of the
subw, oofer.
• You cannot adjust the level of channels set to "None" in
Speaker Set.
• If you are only using one surround back speaker, connect it to
the SURROUND BACK (SINGLE).jack, and atljust the balance
in "Surround Back L".
Use this menu to adjust the network and USB system
parameters.
• Network (Network settings)
Use this feature to view the network parameters (IP
address, etc.) or to change them manually.
The above display is an example.
DHCP (DHCP setting)
When tl-fisparameter is set to "ON", net'a.ork parameters
IUr "IP Address", "Snbnet Mask", "Default Gateway",
"DNS Server (P)" and "DNS Server (S)" obtained from a
DHCP enabled router are displayed. If DHCP server
flmction is not available, set this parameter to "Off" to
configure the network parameters manually.
Choices: On, Off
IP Address (IP address)
Use this parameter to specify an IP address assigned to
this unit. This value nmst not duplicate the one used for
other devices in the target network.
Subnet Mask (Subnet mask)
Use this parameter to specii_y the subnet mask value
assigned to this unit.
For most of the cases, the subnet mask value can be set as
"255.255.255.0".
Default Gateway (Default gateway)
Use this parameter to specie, the IP address of the default
gateway.
109 En