manual

SETUP
Controlling the remote control to operate various functions
En 115
7
Press iENTER to set the number.
“OK” appears in the display window if setting was
successful.
“NG” appears in the display window if the setting was
unsuccessful. In this case, start over from step 3.
8
Press ASETUP again to exit from the setup
menu.
■ Switching between BD player
linked to scene selections
Press eSCENE and at the same time press
dAV2 and hold it for approximately 3 seconds.
“OK” appears in the display window if setting was
successful.
Then you can operate the external components by switching
the input source to AV2, or selecting AV2 in the registered
scene.
Same steps for operating other external components, press
eSCENE and at the same time press the input source key
selected in step 3 and hold it for approximately 3 seconds.
Programming from other remote
controls
The remote control of this unit can receive remote
control signals from other remote controls and learn the
remote control operation. If a key on the remote control
does not work after being assigned with an external
component’s function or if the remote control code for
that function is not provided, use this learning feature to
make the function operable with the remote control.
1
Press ASETUP.
“SETUP” appears in the display window.
2
Press iCursor B / C repeatedly to select
“LEARN” and press iENTER.
2 3
SCENE
1
2
4
ENTER
SETUP
S
OURCE
R
ECEIVE
R
AV
A
UDIO
4
3
1
7
5
6
V
-AUX
4
3
1
2
US
B
MULTI
NET
P
H
O
N
O
TUNER
DOC
K
TU
N.
/CH
[
B
]
[
A
]
i
A
d
e
If you continuously want to set up another code for
another control area, repeat steps 4 to 7.
If operation is not possible and the manufacturer of
your component has more than one code, try each of
them until you find the correct one.
NOTES
• “ERROR” appears in the display window on the
remote control if you press a button not indicated in
the respective step, or when you press more than one
button simultaneously.
• The supplied remote control does not contain all
possible codes for commercially available audio and
video components (including Yamaha components). If
operation is not possible with any of the remote
control codes, program the new remote control
function using the learning feature
(☞p. 115) or use
the remote control supplied with the component.
• Functions programmed using the learning mode take
priority over remote control code functions.
OK
OK
• Perform each of the following steps within 30 seconds.
Settings will be automatically stopped if more than 30
seconds passes since the last operation. To reset, repeat
from step 1.
• If the remote control of the external component uses
infrared rays, this remote control can learn most of its
functions. The remote control may not recognize
special or consecutive signals.
• The keys may not operate the assigned functions
depending on operating conditions of this unit.
Continues to the
next page