Installation manual

ManualsBrandsYamaha ManualsOtherRX-S601D

Choose from the following 2 methods to update to the latest firmware.

Click here for

Firmware Update Through the Internet

(Connection to the Internet is required)

Click here for

Firmware Update by USB

(A USB thumb drive is required)

In case of error, see the

Troubleshooting

section

IMPORTANT NOTICE

Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the

Yamaha website or through your network connection.

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by

Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to restore proper

operation will not be covered under the Yamaha Limited Warranty.

FIRMWARE UPDATING PROCEDURE

Summary of content (6 pages)

PAGE 1
FIRMWARE UPDATING PROCEDURE IMPORTANT NOTICE Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the Yamaha website or through your network connection. Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty.
PAGE 2
Firmware Update Through the Internet Requirement: Internet connection Your receiver is connected to the Internet if you can receive Internet radio stations. (See owner’s manual for details) 1 Power off the receiver (Standby mode) 2 Enter the ADVANCED SETUP mode While pressing the STRAIGHT key, press the (power) key and keep STRAIGHT key pressed until “ ADVANCED SETUP ” appears on the front panel display. * “ ADVANCED SETUP ” is displayed only for a few seconds. 3 Select “FIRM UPDATE” from the menu a.
PAGE 3
5 Check the updated firmware version a. Power on the AV receiver and press the SETUP key on the remote control. b. Select “Network” > “Network Update”. c. Confirm that the firmware version is updated to the latest version. SETUP key Congratulations! You have completed the firmware update. Your AV receiver is ready for normal use.
PAGE 4
Firmware Update by USB Requirement: USB thumb drive, with enough free space to store over 25MB. (File system with FAT16 or FAT32 format) Firmware file provided by YAMAHA, “R03xx-xxxx.bin”. 1 Prepare USB thumb drive for the update Download the firmware, unzip and copy “R03xx-xxxx.bin” into the root directory of the USB thumb drive. Drag & Drop the file into USB thumb drive. R03xx-xxxx.
PAGE 5
6 Start firmware update a. Press INFO key to start the update. (Update process may take up to 10 minutes) * If “ UPDATE SUCCESS ” appears, this means your receiver is already up-to-date. In this case, power off to exit from Advanced Setup. Your AV receiver is ready for normal use. Firmware update in progress Caution DO NOT interrupt power during the update.
PAGE 6
Troubleshooting CASE 1 Error message appeared during the update Cause: Method: For some reason, the receiver can’t read the firmware data. For your solution, check the following [Update through Internet] ❏Check Internet connection. Your Internet connection is working by playing an Internet radio station. (See owner’s manual for details) [Update by USB thumb drive] ❏USB thumb drive is connected properly to the receiver. ❏USB thumb drive is not password protected.