Service manual

DVD-E810
30
DVD-E810
3.2 Timer function
The unit setted in this RX timer function is playbacked at the setting time as the ON-TIME.
It functions even when at setted time the system is already in power on state or the unit is already playbacked.
(1) Timer play
The state is not changed if the setted unit is already in the state of playback.
After sending POWER_ON command, if DVD unit has Auto-play function after power-on, RX will not send
PLAY command.
RX unit DVD unit
Power on process
[Standby state]
[Power shut down]
Power supply through AC OUTLET
Reset start
initialize process
Initialize complete
PORT_PRE_STANDBY
POWER_ON command [DVD state is
neither PORT_PLAY nor PORT_STOP]
PORT_STOP
Power on process
PORT_STANDBY
Wait "ON" setting
time
Switch input function to unit
setted in timer function
PLAY command [DVD state isn' t
PORT_PLAY]
PORT_PLAY
Play process
[Standby state] [Power on] [Play state]
DVD unit can turn on the power by also other key, “PLAY” or “OPEN/CLOSE (EJECT)”.
In this case, it carries out a peculiar function to the key after processing power on. However, only the power on
processing is done by “PLAY” key without media.
When the system is in power on state and DVD unit is in standby state, only DVD unit is changed into power
on state by this operation.
RX unit DVD unit
[Standby state][Power on state]
DVD "PLAY" key
operation
Power on process
PORT_PLAY
Play process