Service manual

DVD-E810

■ TEST MODE

• Starting Test Mode

a. Connect the power cable to the AC outlet.

b. Press the “STANDBY/ON” key while simultaneously pressing “NEXT/F.FWD” and “STOP” keys of the main unit.

At this time, keep pressing “NEXT/F.FWD” and “STOP” keys for 8 seconds or longer.

c. The “FV xx” (firmware version) is displayed.

* The firmware version and region code appears on the TV monitor screen at this time.

• Display Test

The display condition varies as shown below according to the “PLAY” key of the main unit.

• Panel Key Test

The display changes as shown below as the specified key is pressed.

* When performing the panel key test, a remote controller for RX-E810 is required.

Initial display

All segments on

Lighting of segments in lattice

(OFF)

(ON)

• Canceling Test Mode

Disconnect the power cable from the AC outlet.

Press “OPEN/CLOSE” key of the main unit.

Press “STANDBY/ON” key of the main unit.

Press “OPEN/CLOSE” key of the main unit.

Press “STOP” key of the main unit.

Press “PLAY/PAUSE” key of the main unit.

Press “PREV/F.REV” key of the main unit.

Press “NEXT/F.FWD” key of the main unit.

Press any key of the remote controller.

* Be sure to use a remote controller for RX-E810.