Owner`s manual

SETUP
Setting various functions (Setup menu)
En 90
Power Amp Assign
In addition to the 7.1-channel speaker connection, various speaker
configurations are possible using the presence speakers connection,
bi-amp connection or multi-zone function (☞p. 19, p. 20).
Configuration
Displays the speakers connected to this unit or changes the sizes of
the speakers.
Front
Selects the size (sound reproduction capacity) of the front
speakers. J1
Center
Selects the size of the center speaker.
Surround
Selects the size of the surround speakers.
7ch Normal Enables the normal 7-channel speakers and front
presence speakers (☞p. 16).
7ch +1ZONE Enables the normal 7-channel speakers and zone2
speakers (☞p. 18).
5chBI-AMP Enables the bi-amp connection (☞p. 18).
5chBI-AMP +SB Enables the bi-amp connection and external surround
back speakers (☞p. 22).
In the “Configuration,” you can select the speaker size
characteristic (Large or Small). Select the size (sound
reproduction capacity) that matches your speakers.
When speaker size is set to “Small,” low-frequency components
of the speakers that you configured are produced from the
subwoofer (or from the front speakers if there is no subwoofer).
Large Select this for large speakers. The front speakers will
produce all of the front channel frequency
components.
Small (Default) Select this for small speakers. The subwoofer will
produce front channel low-frequency
components. J2
Large Select this when a large center speaker is connected.
Small (Default) Select this when a small center speaker is connected.
None Select this when there is no center speaker. The front
speakers will produce center channel audio.
Woofer diameter
• 16 cm or larger → Large
• 16 cm or smaller → Small
Large Select this when the surround speakers are large.
Small (Default) Select this when the surround speakers are small.
None Select this when no surround speakers are connected.
The front speakers will produce surround channel
audio signals.
• When set to “None,” no sound is produced from the surround
back speaker even if that speaker is connected.
• When set to “None,” the sound programs will change to Virtual
CINEMA DSP mode.
J
1 : When “Subwoofer” is set to “None,” you can only choose “Large.” If the front
speaker setting is “Small” and you change “Subwoofer” to “None,” it will
automatically change to “Large.”
J
2 : You can set the low-frequency components of audio signals transmitted from
the front speakers to the subwoofer by using “Bass Cross Over.”