Owner`s manual
Table Of Contents
- INTRODUCTION
- PREPARATION
- BASIC OPERATION
- ADVANCED OPERATION
- SET MENU
- Adjusting the items on the SET MENU
- 1 SPEAKER SET (speaker mode settings)
- 2 LFE LEVEL
- 3 SP DLY TIME (speaker delay time)
- 4 D. RANGE (dynamic range)
- 5 L/R BALANCE (balance of the main left and right speakers)
- 6 HP TONE CTRL (headphone tone control)
- 7 I/O ASSIGN (input/output assignment)
- 8 INPUT MODE (initial input mode)
- 9 DISPLAY SET
- 10 MEM. GUARD (memory guard)
- REMOTE CONTROL FEATURES
- ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS
- ADJUSTING THE DELAY TIME
- ADJUSTING THE PARAMETER SETTINGS FOR PRO LOGIC II MUSIC
- SET MENU
- ADDITIONAL INFORMATION
- LIST OF MANUFACTURER'S CODES
11
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
SPEAKER SETUP
SPEAKERS
DIGITAL
INPUT
6CH INPUT AUDIO
COMPONENT VIDEO
TUNER
AM
ANT
FM
ANT
MONITOR
OUT
D-TV
/CBL
DVD
P
R
/C
R
P
B
/C
B
Y
GND
75Ω UNBAL.
VIDEO
VIDEO
VIDEOS VIDEO
MONITOR OUT
S VIDEO
CD
COAXIAL
OPTICAL
OPTICAL
D-TV/CBL
DVD
DVD
VCR
IN
OUT
D-TV
/CBL
MD/CD-R
MD/CD-R
MD
/CD-R
IN
(PLAY)
CD
V-A UX
SUB
WOOFER
SUB
WOOFER
SURROUND
CENTER
MAIN
OUT
(REC)
DIGITAL
OUTPUT
OUTPUTAUDIO
MAIN
REAR
(SURROUND)
CENTER
+
–
+
–
+
–
L
R
L
R
L L
R R
AC OUTLETS
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN
: 8Ω
MIN. /SPEAKER
CENTER
: 8Ω
MIN. /SPEAKER
REAR
: 8Ω
MIN. /SPEAKER
MAIN
: 4Ω
MIN. /SPEAKER
CENTER
: 6Ω
MIN. /SPEAKER
REAR
: 6Ω
MIN. /SPEAKER
1
56
3
2
4
Subwoofer
system
Center
speaker
Right
Rear speaker
■ SUBWOOFER jack
When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System,
connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or
rear channels are directed to this jack in accordance with your SPEAKER SET selections. The LFE (low-frequency
effect) signals generated when Dolby Digital or DTS is decoded are also directed to this jack in accordance with your
SPEAKER SET selections.
Notes
• The cut-off frequency of the SUBWOOFER jack is 90 Hz.
• If you do not use a subwoofer, designate the signals to the main left and right speakers by changing the setting of SPEAKER SET
item “1D BASS” on the SET MENU to MAIN.
• Use the control on the subwoofer to adjust its volume level. It is also possible to adjust the volume level by using this unit’s remote
control (see “ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS” on page 51).
Main speaker
Right Left
Left
1
2
4
3
6
5
The diagram shows the speaker layout in the listening
room.
0103V530_9-19_EN(GB) 1/18/02, 6:40 PM11