Owner`s manual
INSTRUMENT AND CONTROL FUNCTIONS
3-16
3
3. Tighten the locknut to the speci-
fied torque.
EC000018
CAUTION:
_
Always tighten the locknut against
the adjusting nut, and then tighten
the locknut to the specified torque.
_
EAU00315
WARNING
@
This shock absorber contains high-
ly pressurized nitrogen gas. For
proper handling, read and under-
stand the following information be-
fore handling the shock absorber.
The manufacturer cannot be held re-
sponsible for property damage or
personal injury that may result from
improper handling.
●
Do not tamper with or attempt to
open the gas cylinder.
●
Do not subject the shock ab-
sorber to an open flame or other
high heat sources, otherwise it
may explode due to excessive
gas pressure.
●
Do not deform or damage the
gas cylinder in any way, as this
will result in poor damping per-
formance.
●
Always have a Yamaha dealer
service the shock absorber.
@
Spring preload:
Minimum (soft):
Distance A = 1.67 in (42.5 mm)
Standard:
XV16A(C)/XV16ALE(C)/
XV16AS(C)
Distance A = 1.67 in (42.5 mm)
XV16AT(C)/XV16ATLE(C)
Distance A = 1.79 in (45.5 mm)
Maximum (hard):
Distance A = 2.02 in (51.5 mm)
Tightening torque:
Locknut:
25 ft·lbf (3.5 m·kgf, 35 Nm)