Installation manual

INSTALL LEG SUPPORT STAND

LegUp has developed a new, stronger

attachment system which holds the Leg

system to the bike! You will need to

remove the two Exhaust Bolts from the

exhaust bracket on the right side in

order to install the support stand. These

Bolts are replaced with two from the

kit. Remove the Black button-head bolt

from the left side of the bike, directly

below the left foot peg. This bolt will

also be replaced.

If inserted into the stand, the long stainless steel shaft with the small bolts in the end should

have one of the bolts removed, and be slid out

of the pipe in the stand. Just set this aside for

now.

The first step is to install the right upright

described above, outside the exhaust bracket

and frame. The spacer goes to the inside (may

be welded in place already) against the exhaust

bracket then the 90 degree bracket outside with

two bolts supplied. Get the bolt holes to line up,

and install the bolts (with a bit of blue Locktite

on the bolts) loosely. The other, longer 90

degree bracket (the one with the rounded relief

on it) is hung from the left side of the bike next where you removed the button-head bolt earlier.

Again, some Locktite and keep the bolt loose for now!

Now we want to slide the support plate

(red above) with the reinforcement plate

(welded on thicker part) facing the ground,

under the bike and supported by the

uprights you just mounted. The four 3/8”

bolts and lock washers you likely just

removed from this plate get a bit of blue