User Manual

R Series Firmware Update Guide 1
R Series and Tio1608-D
Firmware Update Guide
This guide explains how to update the R series and Tio1608-D firmware by using the R Remote (V4.1.0 or
later).
Precautions
 Check the firmware version of the target device before updating. Since Rio3224-D, Rio1608-D, Ri8-D, Ro8-
D, and RMio64-D before firmware version 3.11 are not supported by R Remote update function, you once
need to update the firmware to V3.11 by using the exclusive update software for each product. The
exclusive update software for each product is compressed with the firmware V3.11 which you can
download from the following website:
https://www.yamaha.com/proaudio/
 To use R Remote, Dante Controller must be installed. You can download Dante Controller from the
download page at the following website:
https://www.yamaha.com/proaudio/
 Note that the device may be damaged if you fail to follow these instructions properly, or turn off the device
or disconnect the cable while the update is in progress.
 Yamaha Corporation owns exclusive copyrights for the firmware, its update program, and the update guide.
 It is prohibited to duplicate or modify the firmware, software or guides, in part or in their entirety, without
permission from the copyright owner.
 The screen shots in this guide are for use with this update procedure only and may be different from the
actual screen shots.
 The company names and product names in this document are the trademarks or registered trademarks of
their respective companies.
EN