Specifications

76 RM1x SEQUENCE REMIXER
PATTERN MODE
11. Disk
In the Disk submode, data can be transferred between a floppy disk and the RM1x.
The Disk submode contains the following five groups of operations.
❏ Save
Save Lets you save data from internal memory to floppy disk.
Load Lets you load files from floppy disk into internal memory.
Rename Lets you modify the filename of a file that was saved on floppy disk.
Delete Lets you delete a file from floppy disk.
Format Lets you format (initialize) a floppy disk.
1 Insert a properly formatted floppy disk into the RM1x
disk drive — shutter first with the label side facing
upward. Insert the disk carefully until it clicks into
place. If you need to format a disk first, see “Format”
on page 79.
2 Use Display Knobs 1 and 2 to specify the type and
number of the file to be saved.
Please note that when saving a pattern data as an
SMF file it is also necessary to specify the section to
be saved via the keyboard (the keyboard indicator
corresponding to the selected section will flash).
3 Enter a new file name if necessary. Use Display Knobs
3 and 4 to select a character location and character,
then press the F4 function button (Enter) to enter the
specified character at the selected location. Repeat
until the file name is complete.
4 Press the F1 function button (SAVE!). The “Are you sure?
(Yes/No)” confirmation prompt will appear on the display.
11. Disk
Parameter Values Function
File type PATT, SMF, SMF+TG Header, ALL Specifies the file type.
You can select one of five types of file to be saved. For details on the
types of file, refer to “Types of file used by the RM1x.” (page 43)
Style number U01 ... U50 Selects the user style to be saved.
File name location Sets the character cursor at any location within the 8-character file name.
File name Character A ... ~ Selects a character to be inserted at the current character location.
SAVE! - Executes the save operation.
Default name - Automatically enters the default file name.
Character Delete - Moves the character cursor back one location and deletes the char-
acter at that location.
Enter - Enters the character selected by display knob 4 (CHARACTER) at
the current character location in the file name.
5 Press the
[YES+1]
button to go ahead with the save
operation, or the
[NO-1]
button to cancel. An “Execut-
ing” bar graph will appear while the data is being
saved.
n • Before a floppy disk can be used to save data, it must first
be formatted. (page 79)
• If the size of the data to be saved is greater than the free
area of the floppy disk, a message of “Disk Full” will ap-
pear. If this occurs, delete unwanted files from the disk,
and try the Save operation once again.
• Be careful that you do not accidentally delete important
data from the disk.
• When saving a style, memory numbers for which there is
no data will be displayed as “********”. If you attempt to
save such styles, a message of “No Data” will appear, and
it will not be possible to execute the Save operation.
• The disk write-protect slide must be in the write-enable
position to perform a save operation. If it is not, the “Write
Protected!” error message will appear when you attempt
to execute the save operation.
* For information about how to change values, refer to the Basic Operation (page26).