User Manual

Installation
12 MCP1 (Ver. 5.0 or later) Installation Manual
2. Connect the cable to the MCP1.
To the NETWORK port on the back of the MCP1, connect the cable that extends from the
PSE.
3. Fit the tabs of the mounting plate into the square holes of the MCP1.
4. While pressing the unit, use the included screws with washers to secure the unit in
four locations from the side.
5. Power-on the PSE.
6. Verify that the MCP1 starts.
If it starts, the PSE and the MCP1 are correctly connected.
7. Attach the side panels to the left and right sides of the MCP1.
Attach them so that they click into place.
Next, specify the UNIT ID.
NOTE
Do not attach the side panel yet. If there is a problem with connections, removing the side panel might
damage the side panel or the wall.
MCP1
Side panels