User Manual

Table Of Contents

I/O devices and external head amps

V5.1 Supplementary Manual

Remotely controlling wireless units

Now supports wireless units as remote controllable devices.

• Sony DWR-R03D DWX Digital Wireless Receiver

I/O DEVICE screen (WIRELESS page)

1 Connection status indicator

Indicates whether transmitter control is possible or not.

2 Channel name (transmitter)

Displays the channel name for setting channel names on the transmitter side.

3 TX.ATT knob

Indicates the gain value for the transmitter with a knob. This window is only for display;

the value cannot be edited.

4 TX.ATT

Indicates the gain value for the transmitter.

5 Channel name (receiver)

Displays the channel name for setting channel names on the receiver side.

6 Frequency

Indicates the frequency that is currently set for the RF signal.

7 Audio level indicator

Lights if the audio signal level of the receiver reaches the overload point.

8 MUTE indicator

Indicates the mute status (on/off) of the audio signal for the receiver.

9 Signal quality meter

Displays the quality of the received RF signal. The vertical axis represents quality and the

horizontal axis represents time, and the display of connection status is updated every

second. If you move away from the transmitter, or the quality of the RF signal decreases

due to the influence of disturbing radio waves, the bar graph becomes lower.

0 RF (Radio Frequency) signal meter

Shows bars to indicate the level of the RF signal. An active antenna indicator is shown

on the right side. It indicates which antenna is enabled. In the 4 Diversity mode, the one

with the strongest level among A to D is shown.

NOTE

For details about the relationship between the number of bars and the actual strength of the RF

signal, refer to the DWR-R03D manual.

A Battery indicator

Shows bars to indicate the remaining battery power.

B Control status indicator

Indicates the control status of the device.

NOTE

• When control on the receiver side is possible, the parameter values for the receiver are sent to

the console.

• As the number of remote control devices is increased at the same time, the meter update

frequency decreases.