User Guide

17
◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆
If the amplifier has only one input, use the L/MONO jack on the QS300. If
you are using stereo headphones, connect them to the rear panel PHONES
jack.
2.
Connect the power cord to the AC INLET terminal on the QS300 and plug
the other end of the cord into an appropriate electrical outlet.
3.
Make sure that all volume controls (on the QS300 and the connected ampli-
fier) are turned down. Then, turn on the power of the QS300.
After the greeting display, one of the following displays will appear (depend-
ing on the mode last selected):
● Voice mode:
● Song mode:
● Pattern mode:
● Phrase mode:
4.
Finally, set the volume control on the QS300 to roughly the 3/4 position, set
the volume on the amplifier to a suitable level, and then turn on the ampli-
fier.
Setting Up
CAUTION! To avoid
possible damage to your
amplifier/speaker
system, use this simple
rule of thumb: The
amplifier is the last thing
you should turn on and
the first thing you should
turn off.
GUIDED TOUR