manual

OUTPUT channels

Reference Manual

6 PRE/POST button

Switches the send point of each send-source channel between PRE and POST. If the

button is lit, the send point is set to PRE.

7 SEND ON/OFF button

Switches the send of each send-source channel on or off.

8 SEND PAN/BALANCE knob

Sets the panning or balance of signals sent to the stereo send destination. If the send

destination is monaural or set to FIXED, this knob will not appear.

If the send source is monaural, this knob functions as a PAN knob.

If the send destination is stereo, this is fixed to BALANCE.

9 SEND LEVEL knob

Indicates the level of signals sent to the selected send destination. You can use the

[TOUCH AND TURN] knob to control the level.

Using the faders (SENDS ON FADER mode)

You can use the faders on the top panel to adjust signals that are sent from the MIX and

STEREO/MONO channels to a specific MATRIX bus.

NOTE

• Press the SENDS ON FADER button to switch to SENDS ON FADER mode.

The faders in the Channel Strip section and Master section will move to the send levels of the

signals that are routed from each channel to the currently-selected MIX/MATRIX bus. The [ON]

keys will also change to the SEND ON status.

• If you press the currently-selected MIX/MATRIX bus select button again, cue monitoring will be

turned on for the corresponding MIX/MATRIX channel. This method is convenient if you want to

monitor the signal that is being sent to the selected MIX/MATRIX bus.

• You can assign the SENDS ON FADER function to a USER DEFINED key. This lets you quickly

switch to SENDS ON FADER mode for a specific MIX/MATRIX bus, and quickly switch back

again.

STEP

1. Assign an output port to the MATRIX bus to which you want to send signals, and

connect your monitor system etc. to the corresponding output port.

2. In the Function Access Area, press the SENDS ON FADER button, or press the key

that is currently lit in the SENDS ON FADER section.

3. Use the MIX/MATRIX select buttons to switch between MIX/MATRIX.

4. Use the MIX/MATRIX bus select buttons in the Function Access Area, or the key in

the SENDS ON FADER section to select the send-destination MATRIX bus.

5. Use the faders on the top panel to adjust the send level from the MIX and STEREO/

MONO channels to the selected MATRIX bus.

Function

Access Area