Reference Manual

OUTPUT channels

Reference Manual

7 SEND ON/OFF button

Switches the send of each send-source channel on or off.

8 SEND PAN/BALANCE knob

Sets the panning or balance of signals sent to the stereo send destination. If the send

destination is monaural or set to FIXED, this knob will not appear.

If the send source is monaural, this knob functions as a PAN knob.

If the send source is stereo, you can use PAN/BALANCE mode setting

in the TO STEREO/MONO window to select whether PAN/BALANCE

will function as a PAN or BALANCE knob. The knob for the mode

selected here will appear.

9 SEND LEVEL knob

Indicates the level of signals sent to the selected send destination. You

can use the [TOUCH AND TURN] knob to control the level.

Using the faders (SENDS ON FADER mode)

You can use the faders on the top panel to adjust signals that are sent from the MIX and

STEREO/MONO channels to a specific MATRIX bus.

STEP

1. Assign an output port to the MATRIX bus to which you want to send signals, and

connect your monitor system etc. to the corresponding output port.

2. In the Function Access Area, press the SENDS ON FADER button, or press the key

that is currently lit in the SENDS ON FADER section.

3. Use the MIX/MATRIX select buttons to switch between MIX/MATRIX.

4. Use the MIX/MATRIX bus select buttons in the Function Access Area, or the key in

the SENDS ON FADER section to select the send-destination MATRIX bus.

5. Use the faders on the top panel to adjust the send level from the MIX and STEREO/

MONO channels to the selected MATRIX bus.