Service manual

8-57
– +
ELEC
DRIVE/REVERSE SELECTING SYSTEM
(PZ50GT/PZ50FX/PZ50M/PZ50VT/PZ50MP)
GEAR MOTOR
1. Remove:
• Gear motor
Refer to “SECONDARY SHAFT AND
REVERSE GEAR CASE” in CHAPTER 4.
NOTE:
Since the pinion gear is in the drive position when
the gear motor is removed, be sure to perform the
reverse position inspection first.
Reverse position inspection steps
È
:
• Connect the battery (12 V) to the gear motor
terminals as shown.
• Check that the pinion gear
3
turns clockwise.
Incorrect
→
Replace the gear motor.
NOTE:
The pinion gear should rotate clockwise and stop in
the reverse position.
Drive position inspection steps
É
:
• Connect the battery (12 V) to the gear motor
terminals as shown.
• Check that the pinion gear
3
turns counter-
clockwise.
Incorrect
→
Replace the gear motor.
NOTE:
The pinion gear should rotate counterclockwise and
stop in the drive position.
2. Install:
• Gear motor
Refer to “SECONDARY SHAFT AND
REVERSE GEAR CASE” in CHAPTER 4.
Positive battery terminal
→
Sky blue
1
Negative battery terminal
→
Blue/Black
2
Positive battery terminal
→
Brown/Red
4
Negative battery terminal
→
Sky blue
5
L/B Br/R Sb
3
2
1
È
L/B Br/R Sb
3
45
É