User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
102
d Monitor 1
You can select from Dante Out 1–256 and USB Out 1–8 for the Monitor 1 output.
e Monitor 2
You can select from Dante Out 1–256 and USB Out 1–8 for the Monitor 2 output.
f [Monitor 1]/[Monitor 2] meter
This displays the signal level being output.
g [LEVEL] knob
Specifies the output level.
Procedure
1. With the device in an online state, turn the probe monitor function ON.
The cursor changes to the probe shape.
2. By clicking on any of the output ports for the component, the probe is set as the
monitoring point "Monitor1."
The monitoring point can be moved by clicking on a different output port.
The monitoring point is removed by clicking again on the selected port.
Holding <Shift> key on the computer keyboard while clicking on an output port sets the
probe as monitoring point 2.
Moving and removing the monitoring point is the same as for Monitor1.
The red probe is the point monitoring for Monitor1, the yellow probe is monitoring for
Monitor2, and the green probe is the location interrupting the oscillator.
3. You can select from Dante Out 1–256 and USB Out 1–8 for the Monitor 1 and Monitor 2
outputs. Even if audio is originally wired to the above port, it is replaced with the output
of the Probe component.
4. Turn the probe monitor function OFF to cancel the probe. The mouse cursor display
returns to normal.