User Manual

ProVisionaire Edge Setup

Initial Configuration of ProVisionaire Edge

Note 1 - IP address allocation for network interfaces

Note 2 - Number of PCs running ProVisionaire Edge

Thank you for downloading ProVisionaire Edge. This document describes how to set up ProVisionaire Edge

after installation. For the latest information on system requirements and compatible devices, please visit the

download page.

Only one IP address should be assigned to each network interface on ProVisionaire Edge. If you want to assign

multiple IP addresses to monitor several subnets, you will need to add additional network interfaces on your PC:

one interface for each IP address.

After installing ProVisionaire Edge, launch "ProVisionaire Edge Setting" from the Windows menu and select

the network interfaces to be used.

ProVisionaire Edge can run on one PC within a single subnet. If ProVisionaire Edge is running on more than one

PC, communication between other ProVisionaire applications and devices may be disrupted. Also, it cannot be

used in conjunction with ProVisionaire Monitoring Service: use ProVisionaire Edge instead of ProVisionaire

Monitoring Service.

PAGE 1
ProVisionaire Edge Setup Thank you for downloading ProVisionaire Edge. This document describes how to set up ProVisionaire Edge after installation. For the latest information on system requirements and compatible devices, please visit the download page. Initial Configuration of ProVisionaire Edge After installing ProVisionaire Edge, launch "ProVisionaire Edge Setting" from the Windows menu and select the network interfaces to be used.
PAGE 2
Connections and IP addresses of compatible devices Once you have set the IP addresses of the PC and the devices to be monitored, connect them to the network(s) ProVisionaire Edge automatically detects the compatible devices and registers them for monitoring. For the latest supported devices and supported firmware versions, see the download page. As of March 2023 Device Connector IP Address IP Address Setting RIVAGE PM series (console, DSP) *1 NETWORK [PC] 192.168.53.xxx Cannot be changed.