User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
167
 Specifying a routing
To change a routing, click the point where an input channel and output channel intersect. When you place the
cursor on a cell, the input/output channels will be highlighted, and a blue line will be displayed. When you
click, a routing will be established at that position. If another output channel was already assigned to the input
channel on which you clicked, the previous assignment will not be cancelled. If another input channel was
already assigned to the output channel on which you clicked, the previous assignment will be cancelled.
 Cancelling a routing
Click the “” that indicates a routing; that routing will be cancelled, and the “” will disappear.
 Polarity (phase reversal)
Here you can reverse the phase of the signal. The phase will be reversed if the button is on.
Click
The other input channel is cancelled
Click