User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
164
 Link group list
This shows a list of the link groups. The link groups and the parameters, components, and amplifiers associ-
ated with the groups are shown in a hierarchical display.
You can click to select a parameter, component, or amplifier that is associated with a link group.
 Link group name
By clicking the [+]/[-] symbols shown at the left of the link group name, you can show or hide the lower
levels of the link groups.
To delete a link group, select the link group name and press the <Delete> key. You can also delete a link
group by right-clicking a link group name and choosing [Delete] from the context menu.
 Amplifier icon
These show the amplifiers that contain parameters/components associated with a group. You can use the
[+]/[-] symbols of an amplifier icon to show or hide components, and use a component’s [+]/[-] symbols
to show parameters, Min (minimum value), and Max (maximum values).
You can also delete the selected item from a link group by using the context menu that appears when you
right-click an amplifier, component, or parameter.
 Link
Click this to turn it on/off. You can disable Parameter Link by turning this off. You can turn on/off all
Component links by using the context menu that appears when you right-click the group name.
 Type
Here you can make settings for offset operation between parameters.
• Absolute Link
With this link setting, editing any parameter in the group will set all parameters in the group to the
same value.
• Relative Link
With this link setting, editing any parameter in the group will cause the other parameters to be
adjusted while maintaining their current offset.
• Relative Link cannot be specified for a Speaker Processor or for an 8 Band EQ.
For Component link, you can make these settings in a single operation by using the context menu that
appears when you right-click the group name.
Keep Offset [ON] : A parameter cannot be adjusted further once any parameter in the group
has reached its minimum or maximum value.
Keep Offset [OFF] : A parameter can be adjusted even if a parameter in the group has
reached its minimum or maximum value.
NOTE