User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
154
 Buttons containing a parameter set that is different than when the editor was started
If a button’s parameter set has been modified, the button name will change color. The button will light when
you select it.
• There are no snap buttons for simple components or for the components included in a speaker pro-
cessor.
 Storing a parameter set

Switching the snap buttons
The parameters at the time you switch snap buttons will be stored in the snap button prior to the switch.
1. Click a snap button ([A]–[D]) in which you want to store the parameter set; the button will
turn on.
2. Set the parameters in the editor to the state in which you want to store them.
3. Click some other snap button.
 Recalling a library item (Speaker Processor only)
1. Click a snap button in which you want to store the parameter set; the button will turn on.
2. Recall the desired library item.
 Switching parameter sets
Click a snap button in which a parameter set has been stored, and you’ll switch to the parameter set that’s stored
in that button.
 Copying a parameter set
You can copy parameter sets between snap buttons ([A]–[D]).
 By selecting from the context menu
Right-click the copy-source snap button, and choose the copy-destination from the context menu.
 By dragging and dropping
You can also copy by dragging and dropping between components of the same type. The copy will be exe-
cuted when you click [Yes] to the confirmation message that appears.
NOTE