User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
49
Array Mode (2000Hz, 1/6Oct Band) Single Mode (2000Hz, 1/6Oct Band)
For installation on a plane
• Sound pressure distribution
Displays sound pressure distribution for receiving surfaces with speaker arrays selected from the checkboxes in
Speaker List, and displays the range (dynamic range) using a Sound Pressure Level (SPL) legend. The display range
for the SPL legend is automatically applied through calculation. After display, you can select the minimum and
maximum figures in the display range from the list boxes. You can change the legend display position by setting [SPL
Legend (L)] to [Left Top (T)], [Left Center (C)], [Left Bottom (B)], [Right Top (P)], [Right Center (R)], [Right Bottom (M)],
or [Hide (H)] in the [View (V)] menu.
SPL Mode
Displays a sound pressure distribution in Aspect View for all speakers selected in the Speaker List checkbox. Areas
obstructed by walls (first floor only) or floors are displayed in blue, because the sound pressure of direct sound cannot
be calculated.
Sound pressure distribution for a speaker array (2000Hz, 1/6 Oct Band, Average Value: 85.0dB)