User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
10
Select an array type, and enter the coordinates and angle of the
speaker array. You can also place the speaker array symmetrically.
Select a system type and Y-S
3
will automatically calculate the optimum
array type and coordinates for the size and shape of the room defined.
Y-S
3
cannot perform these calculations for rooms of unusual size or
shape, or for circular rooms.
Configure the parameters for the ceilings, walls, and other plane
surfaces, and then set the speaker layout. There are two methods
available: “Coverage”, where you set the coverage area of the receiving
surface for each speaker and then layout the speakers automatically,
and “Grid”, where you set the location for each speaker manually of a
level plane.
Enclosure type - Manual layout
Enclosure type - Auto layout
Distributed
When you have finished configuring settings, the parameters you have entered and the calculated results appear in
Aspect View, Speaker Property, Speaker List, and Graph areas on the project window.